Configuring your phone to use at home
1) Before plugging in phone, plug in the Power-over-Ethernet (PoE) adapter.
a. Plug adapter into wall with provided DC transformer
b. Plug Ethernet cable into a free spot in your router and connect it to the “Data In”
port of the PoE adapter.
c. Plug a second Ethernet cable into the “PWR+Data Out” port of the PoE adapter.
2) HOLD DOWN THE “7” KEY and plug in the phone, DO NOT RELEASE THE "7" KEY
a. The back of your phone has 4 ports – plug the remaining free end of the
“PWR+Data Out” cable to the second port down. You will know it is the right
port when the phone lights up.
b. Make sure you’re holding down the 7 key until you see the following prompt
3) The phone will ask: CONFIGURE TELEWORKER?
a. Press “*” for yes.
b. Press “#” to enter new settings.
c. IF ASKED, choose "IPV4" by pressing "*"
d. Enter “104#226#13#222” (This will look like 104.226.13.222 on the screen, which
is correct. You can use “*” to make corrections.)
e. Press the DOWN ARROW (usually for volume) and then “*” to confirm.
f. DO NOT UNPLUG THE PHONE WHILE IT SAVES! :)
4) The phone will reset and connect, just like as if you were at your desk
If you're asked for a PIN/passcode/password, it's: 0648306483
Returning to the office
1) Hold down the “7” key, and plug in the phone.
2) When you see “CONFIGURE TELEWORKER,” press “*” three times.
***DO NOT unplug the phone while is saves!***